Extreme-sports.lt

astuoniuke is tikro vadinama FLAMANDU mazgas galima risti kilpa, galima sujungti dvi virves ir is astunkes pasidaro devinke jei reikia ne vienos kilpos o dvieju ausu, mazgo pavyzdys idetas geras

Papasakok kaip surishti trukusia stropa

tai kaip suristi stropa?

cia tikriausiai reikia naudoti slystantiems lynams (zvejybiniam valui) skirtus mazgus

vienas is ju:

Joining Line To Line
There are two top grade knots used to join one line to another, where these are approximately of the same thickness. These are the Blood Knot and the Hangman's Knot - also called the Uni Knot by the International Game Fish Association. Where there diameters are very dissimilar, either the Surgeon's Knot should be used, or the thinner line should be doubled where the knot is formed.

Blood Knot

1. Lie the ends of the two lines against each other, overlapping about 15cm.
2. Take 5 turns around one line with the end of the other, and bring the end back where it's held between the two lines.
3. Repeat by taking 5 turns around the other line, bringing the end back between the two lines. These two ends should then project in opposite directions.
4. Work the knot up into loops, taking care that the two ends do not slip out of position.
5. Draw the knot up tightly.

Bet kaip kompensuoti stropos sutrumpejima?

\

jei vietoj trumpesnio galo risti kitoki po ranka pasitaikiusi lyna(lengvai atitaikyti ilgi), tai reikes mazgo risti nevienodo storio valams:
Surgeon's Knot

Surgeons Knot Earlier mention was made that if the two lines to be joined vary greatly in their diameters, the lesser line may be doubled at the knot, or the Surgeon's Knot may be used. In the latter case, it will probably be necessary to have one of the lines rolled on a spool, or perhaps wrapped on a temporary card, so that it may be passed through the loop.

1. Lay the two lines against each other, overlapping about 22.5 cm.
2. Working the two lines as one, tie an Overhand Knot. It will be necessary to pull one line (say the leader) completely through this loop.
3. Pull the leader through this loop again.
4. Pass the other end through the loop.
5. The formed knot can now be worked into shape.

Na, kas turi praktiskai patikrintu mazgu suristi stropoms?